Rewinding a Garage Door Repair Southlake TX spring can be a challenging task that requires caution and proper technique. It is important to note that working with garage door springs can be dangerous, and if you are not confident in your abilities, it is best to hire a professional.

However, if you feel comfortable undertaking the task yourself, follow the steps below to safely rewind a garage door spring.

Step 1: Gather the necessary tools and equipment Before starting the process, gather the following tools and equipment:

  • Safety glasses
  • Leather gloves
  • C-clamps or locking pliers
  • Adjustable wrench
  • Winding bars (preferably two)
  • A ladder

Step 2: Ensure the garage door is closed and secure Make sure the garage door is fully closed and latched before proceeding. This is important to prevent any accidental opening or movement while working on the springs.

Step 3: Identify the type of spring system There are two common types of garage door spring systems: torsion springs and extension springs. The method for rewinding the springs may vary depending on the type of system installed. Torsion springs are usually located above the door, while extension springs are mounted on either side of the door tracks.

Step 4: Disconnect the garage door opener For safety purposes, disconnect the power to the garage door opener. This will prevent any accidental activation of the opener while working on the springs.

Step 5: Release tension from the springs If you have torsion springs, use the winding bars to slowly release the tension. Insert the winding bars into the winding cone, which is located at the end of the spring shaft. Apply steady pressure in the opposite direction of the spring’s windings, unwinding the spring. Repeat this step for each torsion spring.

If you have extension springs, place a ladder under the springs to support their weight. Use C-clamps or locking pliers to secure the door tracks, preventing the door from moving. Carefully remove the safety cables from the extension springs, then slowly release tension from the springs by unhooking them from the track hangers. Exercise caution as the springs may still have residual tension.

Step 6: Remove the old springs (if necessary) If you need to replace the springs, carefully remove them from their mounting brackets or cones. Follow the manufacturer’s instructions or consult a professional if you are unsure about this step.

Step 7: Install the new springs (if necessary) If you are installing new springs, follow the manufacturer’s instructions or consult a professional for guidance. Installing springs can be dangerous and requires specific knowledge and tools.

Step 8: Wind the springs To wind the torsion springs, insert the winding bars into the winding cone and apply steady pressure in the direction of the spring’s windings. Slowly wind the spring, maintaining control and preventing the bars from slipping out of the cone. Be mindful of the amount of tension you apply to the springs, as an excessive amount can be hazardous.

For extension springs, hook them back onto the track hangers and reattach the safety cables. Ensure the springs are properly seated and aligned.

Step 9: Test the door’s balance After rewinding the springs, test the door’s balance by manually opening and closing it. The door should move smoothly and stay in place when partially open. If the door feels heavy or unbalanced, you may need to adjust the spring tension or seek professional assistance.

Step 10: Reconnect the garage door opener Once you are confident that the door is properly balanced, reconnect the power to the garage door opener.

Remember, working with Garage Door Repair Southlake TX springs can be dangerous, and it is crucial to exercise caution at all times. If you are unsure or uncomfortable with any part of the process, it is best to seek the help of a qualified professional. They have the expertise and experience to handle garage door spring tasks safely.

Southlake Best Garage & Overhead Doors

Southlake, TX 76092

817-385-7628