A Garage Door Repair Wise County TX keypad is a convenient way to access your garage without the need for a key or a remote control. However, there may be times when you need to reset your garage door keypad. This could be due to a malfunction or if you have forgotten your access code.

In this article, we will explain how to reset your garage door keypad step-by-step:

Step 1: Clear the Keypad Memory The first step in resetting your garage door keypad is to clear the memory of the keypad. This will remove any existing access codes and allow you to start fresh. To do this, locate the “Learn” or “Program” button on your garage door opener motor unit. This is usually found on the back or side of the unit.

Press and hold the “Learn” or “Program” button for approximately 10 seconds until the indicator light on the motor unit turns off. This indicates that the memory has been cleared.

Step 2: Enter a New Access Code Now that the memory has been cleared, you can enter a new access code. To do this, press the “Learn” or “Program” button once again. This will activate the programming mode.

On your garage door keypad, enter a new four-digit access code. Make sure the code is easy to remember but difficult for others to guess. Once you have entered the code, press the “Enter” or “Send” button on the keypad.

Step 3: Test the New Access Code To ensure that the new access code is working properly, test it by opening and closing the garage door. Enter the new access code on the keypad and press the “Enter” or “Send” button. If the garage door opens and closes as expected, the new access code has been successfully programmed.

Step 4: Repeat for Additional Keypads If you have more than one garage door keypad, you will need to repeat the above steps for each additional keypad. Make sure to use the same access code for all keypads.

Step 5: Change the Access Code Regularly To ensure the security of your garage, it is recommended that you change the access code regularly. This will prevent anyone from guessing or memorizing your code. To change the access code, simply follow the above steps again.

Conclusion:

Resetting your Garage Door Repair Wise County TX door keypad is a simple process that can be done in just a few steps. By following these steps, you can ensure the security of your garage and make sure that your access code is easy to remember. If you have any questions or concerns, consult your garage door opener manual or contact a professional garage door technician for assistance.

Wise County Door and Gate

1-940-304-0821