Replacing a tension spring on a Garage Door Repair Grapevine TX can be a challenging and potentially dangerous task if not done properly. Tension springs hold a lot of energy and can cause serious injuries if mishandled. It is strongly recommended that you seek the assistance of a professional garage door technician to replace the tension spring.

However, if you are confident in your abilities and want to do it yourself, follow the steps below carefully.

Tools Needed:

  • Safety glasses
  • Winding bars
  • Socket wrench
  • Vice grips
  • Stepladder

Step 1: Release the tension on the spring The first step is to release the tension on the spring. This is important because the spring is under a lot of tension, and if you try to remove it without releasing the tension, it can snap and cause serious injuries. Use the winding bars to release the tension by inserting them into the holes on the winding cone and turning them slowly to loosen the tension. Be sure to keep a firm grip on the winding bars as you turn them.

Step 2: Remove the spring Once the tension is released, use a socket wrench to remove the bolts that hold the spring in place. Place vice grips on the shaft to hold it in place while you remove the bolts. Once the bolts are removed, carefully remove the spring from the shaft.

Step 3: Install the new spring Install the new spring in place of the old one. Make sure that the spring is oriented in the correct direction, with the stationary cone at the top and the winding cone at the bottom. Tighten the bolts to secure the spring in place.

Step 4: Wind the spring Using the winding bars, wind the spring back up to the proper tension. Be sure to wind the spring in the direction specified by the manufacturer. Use the winding bars to turn the winding cone slowly, and keep a firm grip on the bars at all times.

Step 5: Test the door After the new spring is installed and wound up, test the garage door to make sure that it operates smoothly and without any issues. Open and close the door a few times to make sure that it is properly balanced and that the spring is working correctly.

In conclusion, replacing a tension spring on a Garage Door Repair Grapevine TX is a difficult and potentially dangerous task that should only be attempted by someone with the necessary skills and experience. If you are not confident in your abilities or do not have the necessary tools, it is best to hire a professional garage door technician to perform the task. If you do decide to replace the tension spring yourself, be sure to follow the steps above carefully and take all necessary safety precautions.

Grapevine Garage Door & Gates

Grapevine Doors and Gates
Grapevine, TX

1-817-809-2507