Programming your BMW Garage Door Repair Alpharetta GA opener allows you to conveniently open and close your garage door using the built-in buttons in your vehicle.

This guide will provide you with step-by-step instructions on how to program your BMW garage door opener. Please note that the process may vary slightly depending on the model and year of your BMW.

Step 1: Clear Existing Codes Before programming a new garage door opener code, it’s essential to clear any existing codes stored in your BMW’s system. This ensures a fresh start for programming the new code. To clear existing codes, follow these steps:

  1. Turn on your vehicle’s ignition.
  2. Locate the three buttons on your rearview mirror or overhead console that control the garage door opener.
  3. Press and hold the first and third buttons simultaneously for about 20 seconds until the LED light on the mirror starts flashing rapidly.
  4. Release the buttons to complete the clearing process.

Step 2: Obtain Garage Door Opener Information To program your BMW garage door opener, you’ll need to gather specific information about your garage door opener, such as the manufacturer, model number, and frequency. This information is usually available in the owner’s manual of your garage door opener or on the manufacturer’s website. Make sure to have this information handy before proceeding to the next step.

Step 3: Enter Learning Mode Now, you need to put your BMW’s garage door opener into “learning mode” to receive the new code. Follow these steps:

  1. Start your vehicle’s ignition.
  2. Press and hold the button you wish to program (usually located on the rearview mirror or overhead console). Hold it until the LED light begins to flash slowly.
  3. Release the button momentarily and then press and hold it again. This time, the LED light should flash rapidly, indicating that the learning mode has been activated.

Step 4: Program the New Garage Door Opener Code With your BMW in learning mode, you can now program the new code using the information you gathered in Step 2. The programming process typically involves the following steps:

  1. Enter the manufacturer’s code. Consult your BMW’s owner’s manual for the specific code associated with your garage door opener’s manufacturer. Use the appropriate button on the rearview mirror or overhead console to enter the code.
  2. Enter the garage door opener’s specific code. This code is usually a combination of numbers and/or letters provided by the manufacturer. Follow the same procedure as in the previous step to enter this code using the corresponding buttons.
  3. Test the new code. Once you have entered the manufacturer’s and specific codes, test the new code by pressing the programmed button on your rearview mirror or overhead console. The garage door should respond by opening or closing.

Step 5: Save the Programmed Code After successfully programming the new garage door opener code, it is essential to save the changes in your BMW’s system. Follow these steps:

  1. Press and hold the programmed button on your rearview mirror or overhead console for about 10 seconds.
  2. Release the button when the LED light on the mirror or console starts flashing rapidly. This indicates that the new code has been saved.

Conclusion: By following these step-by-step instructions, you can program your BMW’s Garage Door Repair Alpharetta GA opener and enjoy the convenience of operating your garage door directly from your vehicle. Remember to consult your BMW’s owner’s manual or contact your local dealership for any specific instructions or troubleshooting steps related to your particular BMW model.

Southern Home Garage Doors & Openers

3000 Royal Blvd S # A, Alpharetta, GA 30022

1-6789295982