Aligning Garage Door Repair Haslet TX opener sensors is an essential part of ensuring that your garage door functions smoothly and safely. The sensors are responsible for detecting any obstructions or objects in the way of the garage door, and if they are not correctly aligned, they can cause the door to malfunction or even cause damage.

In this article, we will explain how to align garage door opener sensors in simple steps.

Step 1: Check the sensors

Before you begin to align the sensors, you need to check if there are any visible damages or issues with them. Start by inspecting the sensors closely and make sure there is no dirt, debris, or cobwebs that could be blocking the sensors. If there is anything obstructing the sensors, clean them with a soft, dry cloth. If the sensors are damaged or malfunctioning, you will need to replace them before attempting to align them.

Step 2: Locate the sensors

The garage door opener sensors are usually located on the sides of the garage door, about 6 inches above the ground. Look for two small boxes on either side of the garage door, with one being the sending sensor and the other being the receiving sensor.

Step 3: Adjust the receiving sensor

Start by adjusting the receiving sensor, which is the sensor on the side of the garage door that receives the signal from the sending sensor. Use a level to ensure that the sensor is perfectly vertical. If it is not level, adjust the sensor until it is straight. You can do this by loosening the screws that hold the sensor in place and gently moving it until it is level. Once it is level, tighten the screws to hold the sensor in place.

Step 4: Adjust the sending sensor

Next, you need to adjust the sending sensor, which is the sensor that sends the signal to the receiving sensor. Like the receiving sensor, you need to ensure that the sending sensor is perfectly vertical. Use a level to check its alignment, and adjust it if necessary. You can adjust the sending sensor by loosening the screws that hold it in place and moving it until it is level. Once it is level, tighten the screws to hold it in place.

Step 5: Check the alignment

Once you have adjusted both sensors, it is essential to check their alignment. To do this, you can use a piece of cardboard or any other object to simulate an obstruction. Hold the object between the sensors while the garage door is closing. If the sensors are aligned correctly, the garage door should stop closing and reverse its direction. If it does not, the sensors are not aligned correctly, and you will need to adjust them further.

Step 6: Repeat the process

If the sensors are not aligned correctly, repeat the process of adjusting the sensors until they are perfectly aligned. This may take some trial and error, but it is crucial to ensure that the sensors are correctly aligned.

Step 7: Test the garage door

Once the sensors are perfectly aligned, test the garage door to ensure that it is functioning correctly. Open and close the garage door a few times, and check that it stops and reverses its direction when an obstruction is present. If everything is working correctly, the sensors are correctly aligned, and you can continue using your garage door safely.

Conclusion:

Aligning Garage Door Repair Haslet TX opener sensors is a simple process that can help to ensure the safe and smooth operation of your garage door. By following the steps outlined above, you can easily adjust and align the sensors, and test that they are working correctly. If you encounter any issues with your garage door or sensors, it is always recommended that you consult a professional for assistance. Regular maintenance and inspections of your garage door can help to prevent issues and ensure its continued operation.

Haslet Best Garage
& Overhead Door

817-242-5042